Conventional Wrap Style

The standard conventional oil separator is the original design for the removal of oil aerosols from the compressed air stream. This element design consists of a specific amount of a uniform grade of borosilicate glass fibers, “wrapped” onto a support tube.

When properly sized to the cfm/m3/min flow rate and corresponding operating pressure of the machine, this element will provide consistent performance according to the following data:

  1. Pressure drop (initial)

    - 2-3 psi / .20 bar

  2. Pressure resistance

    - 70 psi / 5 bar

  3. Efficiency

    - 2-3 ppm / 2-3mg/m3 residual oil

Pleated Air-Oil Separators

One common method of increasing the capacity of a given sized air-oil separator is through the use of pleated filter media. A Pleated Air-Oil Separator can be suited for approximately 2x the air flow capacity as that of a standard ail-oil separator.

Precision pleat counts
Precision pleat counts
Separator production
Separator production
Pleat Packs
Pleat Packs
KV530-009
KV530-009
View inside a pleating machine
View inside a pleating machine

Deep Filter Oil Separators

A Deep Filter separator uses as many as three different grades of borosilicate glass wrapped onto the support tube in larger than normal amounts. The finished product then achieves increased airflow capacity very similar to pleated air-oil separator, while maintaining low initial pressure drop and residual oil content.

Field testing of this element has demonstrated an improvement in oil separation, especially in high “challenge rate” applications, in which more oil aerosol is contained in the compressed air than is normal.

Precision counting of oil separator wraps
Precision counting of oil separator wraps
Kd285-007 and Kv100-023 oil separators
Kd285-007 and Kv100-023 oil separators
KD900-018 | KD710-009 | KD610-008
KD900-018 | KD710-009 | KD610-008

Spin-On Type Oil Separators

Spin-On Oil Separators consist of a deep bed type oil separator element, placed inside of a pressure resistant body, or “can” like that of traditional oil filters.

Extremely easy to replace in comparison to standard oil separators (which are enclosed in a pressurized tank), this elements design is somewhat limited in application due to restrictions of air flow capacity.

Contact us today to get a custom solution.

Page Load: 1.4962